升降舞臺http://www.qdcbgg.com/線路故障一般的表現是接頭松動，開關和接觸點接觸不好、出現斷線或者元件損壞，這些故障可用萬能表來對其進行檢查。

1、升降舞臺出現線路故障，第一時間內做好匯報工作，及時反饋到相關部門及生產廠家。
Landing stage line failure occurs, do a good job reporting the first time, timely feedback to the relevant departments and manufacturers.

2、用電壓檔來檢測升降舞臺，需要接通電源，然后同樣要根據電路原理圖來對電壓進行測量，通過測出的電壓值來對故障點進行確定和分析。
Voltage detecting gear landing stage, you need to turn on the power, then the same should be measured according to the circuit diagram of the voltage, to determine and analyze the point of failure by the measured voltage value.

3、用電阻檔檢查時，需要把升降舞臺電源斷開，然后通過電路原理圖進行測量，根據測量出的電阻值的大小，來對故障點進行分析。
Check with resistance profile, you need to power off landing stage, and then measured by a circuit diagram, according to the size of the measured resistance value, to analyze the fault.

4、采用萬能表檢查升降舞臺http://www.qdcbgg.com/故障時，可以用電阻檔和電壓檔進行檢測。
When using a multimeter to check landing stage failure, you can use the resistance profile and the voltage profile for testing.